Scratchbuilt oak tree

Oak tree made from wires and clay:

Second attempt at scratchbuilding a tree from wires

After watching some tutorial videos, I think I have improved my skills:

Boogies

Scratchbuilt some boogies for the layout:

Tracklaying started!!!!

Handmade ties:

Tracklaying in the mine area:

Test:

Turnouts build finished!

Finally, all the turnouts that will be used are completed. Upper (logging & station) level:

Lower (mine) level:

Total of nine turnouts (each took about one and a half hour to build) on both levels.

How I build my turnouts by hand

Just a small tutorial on how I make my turnouts. I use Templot to create the trackplan together with the turnouts. I print the template, tape it on the work plank and glue the PCB ties to the template and cut the gaps with a file or a hand cutting tool:

First I start with the heel of the frog. I file the rail to be as sharp and as pointy as possible:

Then I solder the rail to the PCB ties, without soldering the tip:

I file the other part of the heel, to align with the other one:

I solder it and also solder the two rails together at the joining point:

Next is the stock rails. I file the base of the rail, so it will not interfere with the switch rails:

I solder the stock rail onto the PCB ties:

I do the same with the other stock rail:

Next come the switch rails and the rest of the frog, these are all one piece of rail. I file the switch blade ends as much as possible until the blend with the filed stock rail and solder four ties counted from the heel point:

I take two pieces of rail, bend the ends a bit and solder them where the guard rails have to be:

I take a PDB tie and insert it under the ends of the switch blades. When soldering, the gap is kept as it will be when the blade is in the switched position:

A quick test with an archbar truck, that it slides flawlessly on both routes:

Now I cut the gaps at the frog to isolate it electrically:

The turnout is ready for installation on the layout!! For all the photos in full res, check out all the photos in my album.

First attempt at a scratchbuilt tree from wires